View Single Post
  #10  
Unread 04-26-2017, 06:30 AM
surchin surchin is offline
Member
 
Join Date: Feb 2011
Posts: 44
Default

Quote:
Originally Posted by scook View Post
Have you checked your bilge for coolant? I had an overheating problem with my 170 when my outdrive impeller was bad and the coolant pressure caused the back seal in my water pump to fail. The coolant leaked out a relief hole and into the bilge whenever the engine got up to temperature.

If I remember correctly, the front end of the cam shaft drives the water pump and it was scored a little so I got a sleeve for it, installed it, screwed up a seal putting the pump cover back on and with some advice from Spare Parts was able to get it done on the second try and no more leaking.

It's a bit of a job - you have to remove the harmonic balancer, which is part of the alternator. I found all of the magnets were loose, lots of rust on the iron balancer and some corrosion on the coils. I cleaned that up and got several more years out of the alternator.
Oh Ya I've had lots of coolant in the bildge! I have replaced that gasket you mention here and water pump and impeller is good too. I think I have the h b removed for a standard alternator set up. I'm actually not sure what I harmonic balancer does.
Reply With Quote