That's what I have been doing over the years. Is keeping it going piece by piece but this overheat has been ongoing and at this point it's got a lot of exterior corrosion and just not worth the cutting it would take to get all the bolts off to see what's inside. I'm not like you east coast guys with barns. Neighbothood rules about tearing a boat apart in your driveway for my house. They'd turn me in!
So I'm at a
point of repair with new or shop for used replacemt cuddy to get me out on the water.
Got new outdrive SEI. Brand. New trim pump. Hull is ok. Usual wet foam below Good transom good trailer. So Ya that's where I'm at.
Just wondering the overall process if someone been through it.
Thanks c