V21 owners - cuddy bow slider .................
Four screws hold the slider onto the track.....with the lighter additional pull out sliding under the main section.
Installing new screws ( if needed ) can be interesting.......
Unless you want to remove the entire assembly to fit the screws, getting a very short flat head into place, with equally small nut is a bit of a challenge.
Anyone know what I'm referring to ?
After doing this, I've found the minor slider hits on the screw heads, and sometimes gets hung up. So, I plan to remove the screws, remove the washer I used as a spacer ( that's causing the problem), re install and cut off the end of the screw if it's still sticking out too much.......or find a shorter stainless flat head screw and fumble in the small slot to fit on a nut.
Always something you can be working on with a boat.............
|