This is from page 4 of my transom repair thread
"Since I have clear access with the back cap off...
Added the new rodholders and flush cleats.
I wanted some 30 deg rodholders angled out 90deg. There is no way to get them in gunnels because they are too narrow.
I found these from Gem-Lux. They don't have screw holes so they are only 3.5 inch on the diagonal instead of normal 4.5 inch.
Put the rodholders right over the old holes for the cleats.
Thought they would clear the tubs in the transom hatches but they don't. 15 deg holders would clear or angling them out 45 instead of 90 would work. There no changing your mind...once you cut an angled hole thats it.
so now I have to figure out what to replace the tubs with. Only use them to hold boat soap & hand cleaner I think I'll tab in some rails to inside transom and the cap wall to mount a shelf. Thought about mounting a bucket in there but it would never come out once the cap is on.
If I ditch the tubs I'll post them here cause people are always looking for them.
Cleats went in easy. I like them. Don't use the stern cleats much since I clip to transom u-bolts."
|