Had a little time today between work and kids hockey practice so I pulled the tank hatch off, which was not sealed or fastened at all. The tank was foamed in nice and thick. Of course the foam on top of the tank was completely saturated in water and or fuel. I got most of the foam off the top of the tank. I was mostly just curious of what the tank looked like. I can imagine it's going to be a nightmare releasing the tank from the foam.
I think I've come to conclusion to keep this hull the cuddy cabin. At this point it's obvious the stringers and floor are gone. Floor has some solid spots but many soft ones too. I'm assuming this may be from the parquet core they used. It seems to have worked properly, only rotting the pieces that had water intrusion. But it seems it has many places for the water to get in.
I was going to cut the floor out tonight but I am now debating trying to get the whole cap off. Just trying to figure out how to do it. It seems stripping as much as I can off the cap to lighten it up. It sucks that I cut the rear of the cap off now that I'm planning on doing this but hey, it is what it is. Planning on removing the cap this weekend.