1. Outer edge transom well aluminum trim.....
Good idea, I did the caulk thing. Sounds like a good winter project.
2. Port side transom storage section ( oil tank )
Previous owner replaced hatches. Hatches have rubber seals. No water gets in mine. Also, see #5.
3. Bow slider, water drip into cuddy
Mine gets wet in heavy seas or rain trailering down the road. Not very often and I keep the boat in my building indoors, so not too worried about it. I also run a dehumidifier and open hatches to air out when boat is stored.
4. Hull rub rail around boat
Have not worried about it too much. Previous owner put a new rub rail on it and caulked all the screws. I think I'm ok there for now.
5. Rod holders drain into hull
Plumbed all of 4 rod holders so they drain into the bilge using Reelapeelin's method. That always bothered me.
6. Deck access plate over fuel tank
I don't understand? Mine's integrated into the deck. It is not an "access" unfortunately. There is an indented outline of the tank in the skin but the floor is a solid piece. Never been cut/removed. Wish it was remove-able though b/c I'd love to be able to access my tank.
7. Windshield hinge
I need new windshield supports and need to spend a little time working on it. Hinge seems fine.
__________________
1994 Wellcraft V21
|