Quote:
Originally Posted by Destroyer
Take a straight edge and put it along the bottom of your boat running fore and aft. Check that there is no gap from the transom to a few feet forward. I'm wondering if you might have a little cupping in your hull. (Cupping is caused by too short a trailer not supporting the stern properly so over time the hull actually bends down a little because of the weight of the engine). I highly doubt it, but since you don't have any tabs, and only one transducer on one side it's about the only thing I can think of.  |
I'll take a look at that soon as I can. I know for the past 15 years it was kept in a boatel and I'm sure they knew how to support the hull. But then again who knows and there's still 22 years before that something could of happened also. I actually dropped it off today to the fiberglass guy to finish the top off so I'll talk to him about it too. He will know what to look for.