energized that crappy system yesterday and went to testing. everything came on and worked except the anchor light. looked at and touched all th wires as best as i could, everywhere that i could. everything actually looked good and nothing was warm, except the anchor light hot wire. it was pretty warm. pulled those two wires. they were both black and very stiff, like automotive wire. sure enough, near the light on the hot wire was a connector where the wire had been spliced. could see corrosion and evidence of arcing. replaced those two with tinned wires. took a closer look at all other wiring and it all looks correct and in good shape. heading out there soon to install my blue seas fuse box, solder and heat shrink all connections and clean up the wire routing. then just add my gps, vhf, second bilge pump and a couple other acc and this phase of the project should be done by lunch tomorrow.
|