Skill saw set to appropriate depth - can do that I think, my only concern was/is if enough clearance right there where the seat boxes are. It is right at 1.5 inches and I'm trying to stay in wellcrafts "cut here" lines, because I do not want to repaint my deck. Also would need to jigsaw the corners as not to overshoot the corners.
Cleats under lip, care to elaborate? Glass in some type of tabs from the underside? If it were beefy enough from the underside could I not just bed it in on the tabs with epoxy then 4200 or 5200 in wellcraft's "cut here" lines kinda like a removeable hatch cover?
This sux. Why the he!! isn't there a removeable hatch cover. !?#^@%$!
__________________
1994 Wellcraft V21
Last edited by Blue_Runner; 05-02-2016 at 04:36 PM.
|