thanks skunk. after looking around the forum for as long as i have, i was hoping you would chime in. was hoping for more replies too but it that time of the year, most peeps are out enjoying there boats or working on them.
if i do this i will definitely be removing the liner to get at everything. ive also given some thought to seacast for the stringers. my biggest concern with that stuff is weight. ive read that it is very heavy and that it is lighter than wood. would definitely be a lot easier. ill have to do some cost analysis and give it some consideration.
any idea where i can find some good reading on the floor repair procedures or some guidance? what materials to use and maybe a lay up schedule would be a great help! i like to learn as much as possible before doing or even considering such a project.
i did have an idea earlier, maybe my dumbest ever lol! what if after the transom and stringers are sorted out i didnt even replace the rotten wood in the floor? since corsa and the like are too expensive for my budget, what if i cut out the rotten wood and instead of replacing it and glassing it in i just glued the correct thickness foam board to the underside of the deck so that it reaches the stringers properly and then filled all the voids underneath with foam? i could screw some generic plywood down on top of the deck to keep it from bulging and heaving and fill her up!
|