Quote:
Originally Posted by 504V20
twh, you mind telling me what kind of trolling motor you installed, shaft length and are you happy with it? considering trolling motor for bow of my v20 and concerned about shaft length...thanks in advance
|
504...I went with the minn kota I pilot 80lb. 60 inch. shaft. The 112lb. 36 volt would be sweet but didn't want to deal with the extra battery and cost of the 36. As far as shaft length goes the 60" gives me close to 24" in the water. After adding 2 group 29 batts. in the cuddy,the pulpit which was a few pds. and the wt. of the trolling mtr. on the end of the pulpit the bow does sit a little lower at rest. I have only used it on the lakes so far and average about 3-4mph (gps) at full power.