Quote:
Originally Posted by Striper80
I have a 98 Johnson 200. Earlier this spring the tilt/trim was working fine. I had to pull the engine off to remove a bolt that was sheared off on the upper part of the engine on the steering arm. When I reconnected all of the wires and controls yesterday the engine will only go down. I only hear the one relay clicking to make the engine go down. I swapped the relays and I got the same result. I checked all the connections and everything is connected. I was able to raise the motor to go up by putting voltage directly to the motor. I'm just wondering if anyone has any recommendations where to start my diagnosis?
|
You have 3 wires blue/green/red. The red is 12v+ and then supplying voltage to the green wire will make the engine trim down and to the blue will make the engine trim up. I would crack out a test light and just start checking for voltage while someone holds the trim button going up. It sounds like the down relay just isn't getting 12volts to it.