I can't always get twine to go where I need it. So, I cut the end off an old shift cable and pulled out the stainless steel core. It is flexible to some extent and yet stiff enough to serve as a poor mans fish tape.
Agree whole-heartedly with leaving an extra piece of twine for next time.
Welcome aboard. IMPO you will never regret having done this yourself. The knowledge of what it is, where it is and how it is wired may literally save your life one day.
Now is no better time than to replace the bilge pumps, switches and hoses. RULE makes a good pump. 1000 gph or bigger is what I would recommend and consider adding a second bilge pump with its own switch as a backup if the previous owner did not.. I have a couple pumps in the bilge because my boat does not self-bail like most. My pumps are tested before every trip. They are 100% or I ain't going. Yes I am ANAL! I am not an expert. I can tell you what works for me in the past 35+ years.. The book makes for good reading. Then go get your hands dirty. It isn't hard at all, and you will gain valuable experience.
__________________
1996 -19' NV Flats 115 Mercury 4-stroke
1983 -20' Wellcraft Center Console 250 XS
|