[THEFERMANATOR]

I got my 3.3" ID chiney pipe swapped out for a 4.3" ID pipe. I also added on an adjusteable damper to it. Seems to be doing a bit better now, and not choking back so easily. Another thing I found is my supposed top of the line thermometer is WAY off in temp. My 1st burn in after swapping the chimney pipe I got it up to 400 on the gauge, but I put my digital temp probe in it and found it was almost 500 inside at the thermometer. The thermometer stalls out in the 200-225 range and goes from reading higher than actual to lower than actual right in the sweet spot for smoking temps. When it's 75 degrees, it shows 100, but when it shows 300 it was actually 375. So I have to get another thermometer for it. After moving it back to my porch, I added in a roof top vent pipe setup so the chimney outlet now goes straight up instead of through a 90 and out into the wind. It's a VERY windy day today, and all the exhaust seems to be going straight up and out. Will find out here in a little while how it all does together as I'm doing my 1st cured meats. Got some whole pork loins, put in a brown sugar honey cure for 5 days at 40 degrees, and got em in the smoker now hoping to make some canadian bacon.

Heres the smoker on the porch, and you can see I have the 4.5" OD chimney pipe going tinto a 6" furnace pipe, and finally up into a 8" outlet with rain cap.


Also built me a wood rack so I can dry my smoking wood somewhere than my back porch taking up space.


And finally, anybody with a nice smoker needs a log splitter to split up your smokin wood so you can get em how you want em.