go back to post #32, that is the size of the drains i installed in the forward and aft bulkhead in the tank compartment. the original was a piece of 3/4 pvc, which was continually getting stopped up. the tank is sitting on 1/2 pieces of foam off of the hull on the sides. this allows air and water to drain to the bilge when inclined. any water in the bilge will flow freely in and out of the fuel cell compartment.
this is the part that concerns me. still not sure if i am going to leave like this or not. considering glassing a larger drain pipe to the bottom and sealing the compartment.
|