Found my pin pushing tool (Radio Shack) to change around a couple of Molex connectors. Mercury sent the controls for an I/O instead of an outboard the main difference is that the trim switch has four wires? Harness only has three and the plugs are very different. I can surmise the extra wire is for some version of trim limit/trailer tilt ? Who knows but the plastic molex 4-wire connectors from Radio Shack did the trick. Used the same setup for the jack-plate control wires. Ran new 1 Ga primary wire from the battery under the console to the transom and yanked the 18 year old jumper cable wires and extention chord (Orange) that the builder used to wire the old girl originally. I have literally changed every wire.
A few connections to solder up and we will be running in no time.
__________________
1996 -19' NV Flats 115 Mercury 4-stroke
1983 -20' Wellcraft Center Console 250 XS
|