Thanks again Tartuffe
Off the next two days, hopfully be able to get to Harbor marine and pick up some supplies.
What kind of ply did you use Tartuffe?
Im thinking of going cheap and using Fir, however Ive been told Okume BS1088 Joubert, Meranti BS1088, or Meranti BS6566, are the have trade-offs for the cost. The BS6566 I've been told is best for a structural/ resin fiberglass bonding and it will bend easier to match the transom curve and is stronger, the $20 etrxa per piece may be worth the trade-off.
What would you use??
Last edited by brywheat; 07-09-2014 at 02:25 PM.
|