Thanks! What is so confusing is that it runs well, certainly that cylinder is firing correctly.
I will pull the plugs and see whether there is a difference between that cylinder plug and the others. That's about all I can do because as you see in the photo, the boat and motor are in the water in a marina--and my boat trailer is being rebuilt.
I would like to put the muffs on and flush it with fresh water, but I can't reach far enough from inside the boat to put the muffs on when the motor is tilted up. I might be able to angle the boat in the slip around to get the lower unit near enough to the pier. I don't see the others flushing their motors, so maybe that sea water is not so bad. Nearly everyone tilts their lower units up out of the water like I do.
Larry
__________________
1975 Wellcraft V20 Steplift with 1979 Evinrude 150. Newly rebuilt dual axle trailer. Boat is in a slip behind Harbor Island on San Diego Harbor.
Last edited by Larryrsf; 07-01-2014 at 10:59 AM.
|