Quote:
Originally Posted by DiverDux
Repair/replace throttle.
Secure seat at helm to floor.
Bolt the hinges to floor hatch with nylabolts or threadsealer.
Clean and oil teak trim.
Tach isn't reading accurately, determine cause and repair/replace.
Power wash and paint bottom.
Clean, polish & wax hull.
|
Hello all-
Well the boat is wet as of yesterday. The list is mostly complete a few additions and a few things we decided to postpone for a bit.
New nuts and bolts to the floor hatch.
Cleaned and coated teak.
Cleaned and waxed.
Replaced the tach.
Had a problem shifting into and out of gear, so we replaced the linkage to the outdrive. Needed to pull the outdrive to do the repair so we replaced the boot, gimbal bearing etc.
Decided to look at the stiff stearing. replaced the helm with a new anti-feedback steering system.
Replaced the factory ignition with a solid state ignition.
Attempted to secure helm seat base... aborted for now. See our plea for advice in the repair section.
Decided not to re-paint the bottom. Considering a permanent coating for the bottom. Thinking next year.