bs, they are a standard size. the brand is dexter. don't know much about them, i bought them from a local trailer builder ( hi-tech). i believe the measurement they go by is the frame width. mine was 71". i have never had hubs like these before, guy said they are star shaped to allow access the brake bolts on the brake flange. these also have the accu-lube spindles, this allows the grease to pass through the axle and come out just inside of the seal and pass through both sets of bearings before coming out end around the castle nut. i've had that on this trailer since 96, never had a hub failure. i can repack the bearings and never pull the hubs. i just alternate the color of the grease every time i repack to tell when all the old is out.
i know the float on's set low and used the small wide tires, don't know if that 's going to be a problem. i know you can get the angle of the arm in different degrees.
|