Quote:
Originally Posted by phatdaddy
most were made in the sarasota plant. gotta remember, these hulls are 20 to 30 years old, plus the materials & techniques were still evolving.
when i cut out & replaced my deck, i bonded a 1/2 wooden tab to the underside of the lip like a shelf around the cavity. i then cut out a piece of 1/2 ply to fit the hole, then glassed over & faired to the original edge. this left the everything flush on the deck.
|
Thanks for the info. I'm not questing the technique (ok may be the foam!) but when you are a DIY (like me) you can spot shoddy work, and I'm seeing some obvious corner cutting production and/or inexperience. I'd like to think by 1988 Wellcraft knew how to make a boat and especially this one!
One question on your deck technique. I think you are suggesting what we are going todo. We are discussing putting a lip around the civility of the sole too so the new sole sits in like a hatch. It appears th eold wood is 1/2 and we are going to go 5/8 or 3/4 and thus have it raised...and basically have a water channel around the permitter as we have cut back around the entire deck to 1.5" from the wall. Is this what you are explaining to other then a flush deck?
We have a leaning post, centerconsole and t-top and want more thickness in our wood. Do you think we are overkilling on thickness or does it sound like increasing makes sense with our deck variables?