Quote:
Originally Posted by Liam
While you are in the bilge area,providing you transom is good you may want to cut a mousehole and fill with resin and 1/4 chopped strand around the garboard plug,then redrill for a new garboard plug,leave the outer layer of the transom glass in place and fill from the inside,this will increase the life of you transom.
|
Man you got the best info! I'm following your solid to the "mouse hold discussion".
A surveyor on site when we picked up the old boat give our transom a "solid" rating...but that is about all we found solid. Should we clean up where the transom meets the hull and re-tab that out too as well as the drain comment from you?