[Liam]

Hey sorry i misinterpreted what you where saying with the deck,you will be fine using the perimiter to attatch,i am doing the same.
I have saddle tanks so am raising the tanks 3/4 inch to allow for the overlap.
I am only using one layer of 1708 on the stringers,50 inch will do both my stringers,tabbed in with 6 inch 1708 tape and CSM in the tight corners.
I suspect your stringers are taller than mine though so you may need to use one length of 38 inch per stringer.
For the deck i plan to use one layer of 1.5 oz CSM on the underside then one layer of 1708 with a layer of 3/4 oz CSM on the topside.Thats with 1/2 inch ply.
My stringers are longer than 8 feet, as the stringer is made from 2 pieces of 3/4 ply i just cut one piece 12 inches shorter and do the reverse on the next section of stringer,glue with resin and stainless screws,then one sheet of 1708 over the whole stringer.