Although I've done this a couple of times before, it's been a while...installing tabs is pretty straightforward, but can be a little tricky...first thing I realized it would go easier to remove the slats from the swim platform...a whole lot easier than taking the whole thing off the transom, than resealing and reinstalling
The shackle is through an eye attached to the trailer for the transom straps...the ones that WON'T go through or around the tabs now...so gotta provide a new attachment point up on the transom somewhere
The tricky part...especially if you forgot it from last time...is to drill the through hole for the nipple BEFORE you drill the screw holes...hope they line up
Gotta make a small bracket for the pump to sit on inside the bilge and mount the controls on the dash, run the wires and all that...a post for later on...
