[RidgeRunner]

Thanks for the compliments Bill,
The hull started life as a Outboard, transom cut down to 25" with the splash well built into the liner. The console is a modified version of the original. I can get pictures of the inside. The core was rotten in the liner and 90% was replaced during the cap-off rebuild. I decided to make it a full transom boat. Once the hull was changed at the transom I had to make the liner match the hull. The grinding alone was daunting.
I had several cameras stolen during the rebuild so very few pictures. I have a 35mm picture of the liner flipped upside down on a jig I made. All of the core in the floor had been removed.
Factory console, I shaved the rod holders and seat off, extended the base down 4" (making the console taller) and added a mounting flange on the inside, cored the sides of the console and then added the top piece to flush mount the electronics. When all was said and done I made a starboard cabinet and face to fit underneath and a faceplate with three access doors to finish it off. A might heavy and too-tall but very custom, LOL.