Hot coated the pre cut core material and thickened the left over resin to fill voids around the top of console (always take advantage of what you have mixed,it will save you a lot of resin in the long run)
I then let the hot coat kick then mixed my thickened resin and applied with 1/4 inch notch trowel.
I then put my core ply inplace and smushed it around to get an even layer of thickened resin between the ply and console skin. A big mistake I've learned is squeezing to much resin out of the bonding surface. Always keep a thin layer of resin in there or you won't get a good bond.