Quote:
Originally Posted by bgreene
1996 Evinrude 150 -225 How to start cold engine:
1. pump fuel bulb fully / repeatedly till firm. Don't over rush, do it right.
2. turn ignition key while holding the key pressed in to choke.
3. when it starts, release the choke.
During very warm weather, I find less choke is needed, but when it get's cold this is the factory starting proceedure. If it starts to die, just press the key in to provide shot of richer choke and release again.
I've had two of these motors - and confirmed starting proceedure with Evinrude Master tech at J&B, Westville, NJ - 50 years of family run Evinrude dealer / service .
|
I had already looked this up and you are dead on, and Thank you.