[tartuffe]

Time for an update and a few pics. I wish I had taken a few of the structural work prior to the flip but there will be time for that later. I've glassed in the stringers and the grid outside of the stringers leading to the chine. All the wood for the anchor storage, additional hull support near the bow and storage compartments and supports is cut and shaped for moving the batteries just forward of the console under the sole. The transom is about 85% fair, pretty smooth but will need a couple small areas touched up.

The hull is flipped at this point and the first coat of Interlux A2000 E is on. Now I will start with fairing the strakes and filling and rounding the knicks on the chines, then 4 more coats of 2000, sand with 80 grit followed by Interlux VC Perfomance. Above the waterline will be primekote followed with Mauritius blue.

Now the bad part. Seems I can't catch a break. What I thought was isolated soft spots in the sole turns out to be the entire thing. See pics. I've ordered 1/2" divynicell that will be here week after next. Now to build an additional platform for the sole to rest on that will not allow the unreinforced sole to warp. Yee-Haw