Phat i have figured out the black wire with yellow stripe is for shut off, the red wire with yellow stripe is for starting. Yellow wire with black stripe is for choke, the brown wire is for the overheat sensors but on the outboard side of the connector its a brown wire with blue stripe. Purple wire runs into the motor and stops at a terminal block. Previous owner had it hooked to a fuel pump. Gray wire goes behind the coils into a black box so i think thats the tach wire. I have 12v between the red and black wires so they supply power forward to the ignition switch.
All i have left of the oil injection is the warning box. There is a blank plate over the crankshaft hole.
I have no brown/white wire. Heck i dont even have a trim sender.
\
Wiring diagram below, it would be nice if they labeled 1-8 on the connector with what they do.
