To do list on my 96' V21 down to these ..........
1. DONE Finish installing transom well rod holders
2. DONE Re locate the trim tab hydraulic pump inside the transom well - since the rod holder
bolt now intrudes where I had the hydraulic pump. Oops.
3. DONE Replace and install the new transducer for the Garmin 160C. ( never mind that story)
4. Clean boat, then load with essential gear.
( clean boat means inside and out with the full regalia of products, lots of man hours)
Then........... take the rig to the water to photograph so I can show you all, and keep the photo's for reference.
Of course, also test drive performance check with the new trim tabs.
Then.............. re cover boat and wait for the right time to kick off New Jersey salt water fishing season.
Last edited by bgreene; 04-01-2012 at 05:57 PM.
|