Quote:
Originally Posted by 20'fisherman
Thanks for the info. I am located in Panama city Florida. There is no bottom paint' i have already removed pin stripes and decals. There is not much fiber glass work that needs to be done other than under the rub rail where it has a ton of screw holes. Also there is one hatch that needs to be replaid in front and two small hatches in the back on left and right side. I was also thinging about moving the live well up off the floor and and try to add it to a leaning post. Any ideas where to buy somthing pre-fab like that. It will be no problem removing motor and controls have a buddy with a boat repair shop that could store it for me.
|
I would think SEVERAL(if not MANY) shops in PC can do an excellent job for you...my suggestion would be remove motor, hardware, etc, get a start on taping and trailer it around to those shops for price estimates...look at their past jobs every chance you get and references from past customers are always helpful...
Off the subject, but I sure loves me some Cape San Blas down there...that whole area from PC to Carrabelle is SWEET place to be...
