Heres the measurements for the transom, My true floor height is 13 1/2 inches off the keel. Im gonna build the angle floored splash well but I need some specs.
#1 how high is the "curb" or wall height off the sole(floor)
#2 how deep is the splash well(inside measurement from transom to wall) so I know how deep to make for tilting motor?
#3 whats the angle of the pan in the splash well (low point referenced off 20" transom offset) and (high point referenced off top of "curb" or wall?
Then after I build the splash well I can mount the motor and figure out after i launch what way to drain the deck. If I find out my sole is high enough off water level then I will put the ball scuppers on either side of splash well at deck level. If the floor is lower or at water level then I will cut half circled in the bottom of the splashwell wall to allow deck water to then drain into the sump that I have installed assisted by a bilge pump.
Does this sound like a plan? SMOKE and REEL thanks for all the help fellas!!!!!
