I aquired a large well water pressure tank the size I really been wanting to build a smoker/grill out of.
Cutting legs for the stand
Legs cut out ready to go on the tank. This is after cutting the bottom off and removing the rubber air bladder. Tank was clean inside, just a little rust.
Squared up and welded with 1.25" flat bar
Had these nice heavy duty casters laying around:
Legs on, firwood rack started:
Firewood rack done, wheels welded on:
Rack/ stand completed:
End cap on:
Started mocking up for the grill rack:
Started cutting out 1/4" plate for the firbox:
More to come!!