This question is for all you structual guys on here. I was thinking about returning my glass over my cap and tie it into the outside hull down the side about 2 or 3 inches. Is this a wise move? there is a reason why factory did not glass the insert or cap or guwals to the side of the boat. I personally think if I glass the cap in this manner to the side of the boat it will be a constant flex and crack issue ultimately leading to an astetic eye sore . Any opinions would be awesome. As you can see in the picture my cap is made of wood which Im gonna laminate a nother piece of 3/4 acx to to beef it up. Im then going to band the inside edge and outside edge with 3/8 acx router all edges and then glass with 2 layers of 1.5 csm. would this be a proper schedule for this application or should I go with one layer of 1708?
|