ok now the plot thickens. i do leave it in salt water in a slip. so it should be attached to engine mounting bolt,( or if you have a threaded drain plug, to one of the screws holding the drain plug housing) . do you mean the brass garboard drain? my brass garboard drain is screwed in from outside the boat with stainless steel wood type screws and 5200 caulk. is that what you are referring to?
not sure where or which engine bolt on the outboard i could attach it to. would you run it out thru the harness to something on the outboard engine?
i'm wondering if this may be a cause for all the corroded aluminum fuel tanks?
Last edited by pancake; 09-02-2011 at 10:03 AM.
Reason: spellin
|