Look in the top of the flywheel you'll see three threaded holes (5/16 fine thread I think). If you have access to a welder, cut a plate and lifting eye, weld them together.
With cardboard, place over the holes for a pattern by lightly tapping with a ball pein hammer. Drill or cut the holes and transfer the pattern to the lifting plate.
Careful to use the correct length bolts. Don't run them in too deep and damage the stator or the like.
dang, FERM and spare bet me to it. I'm getting slower and slower trying to post
__________________
'75 Cuddy with '00 Johnson Ocean Pro 150 horse
Benny
|