Quote:
Originally Posted by willy
Yea Ozzie I have loaded and unloaded at several diffrent ramps, with just the back wheels of the trailer in but the trailer sets to high for that to work well.
So I would pick up a single type roller, put it where the current double rubber stopper is mounted and lower the whole unit on the post (I can go down about three inches) and run the cable for the winch right over the top of the new roller.
Did I get that right?
|
I don't THINK so....most I've seen pull the bow eye up just BELOW that roller....if your cable goes OVER the roller, it'll cut it up pretty quick...