first three pieces went in very nice. Next three were going to be really tight and we didnt want to slam them in to hard with a sledge . So we measured the four inchches off the sides and the bottoms and ground off three of the eleven layers of plywood those four inches to get them to fit tight withour forcing them.
We removed the screws from the first three pieces and used then to pull the two 3/4 inch sheets together. I bought good stainless screws and decided to leave them in for extra strength. they should be fine seeing as they will be buried in fiberglass.
Here is a pic of all six pieces of wood in. the fiberglass is also beveled about 3.5-4 inches out for the new glass.
|