Re: Towing vehicle rear end!
The metal clips are there to keep the adjusters from backing off. If you have to much movement you need to replace the bearings in it. If you can get ahold of the special tool for adjusting the bearing pre-load it isn't a bad job to do. The last 8 1/4 I did cost me around $60 in parts and about 2 hours of my time.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR
2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD 
AND THE PINK JEEP!!!! R.I.P.
http://www.wellcraftv20.com/communit...ad.php?t=11664
|