Quote:
Originally Posted by chumbucket
That's why you cut the X in the rubber cap. It really doesn't leak like you think it would. I store my kayak in straps on it's side and I loose very little water. You can always cut the bottom of the PVC coupling in a V to fit the keel of the hull. Then epoxy it with 5200.
|
The 21 has two bilges...forward one, just aft of the fuel tank is where the bilge-pump is located center-line...that's the only one I would try to do this as aft bilge is quite difficult to access...anyway, there's no place on the keel to do it...it'll have to be up the hill to port side as water intake is starboard and probably causes some turbulence...anyway, I'm goin to Lowes tomorrow and get the PVC and a cap...thinking of painting the X cut where the cable goes thru w/liquid electrical tape...Thanks a ton, CB!!...really appreciate all the pics!!