Hardtop Info for V20
I had mine made and installed at Shore Towers in Brick,NJ for $3200 with 6 rod holders and a 1 inch thick "honeycomb" top. I LOVE MY TOP but I'll pass along my only misgiving....
It is really strong, even OVERbuilt for what is needed. The guy said it would be strong enough to put a helm up there! He wasn't lying. But I'm not in Florida lookin' for weed lines.... I have done cannonballs from up there when the fluke don't bite.
He used 6 attaching points instead of 4.
The "problem" is that the windshield door can't open all the way to lay flat on the port side because it hits one of the legs of the frame. It goes just past half way so it will stay open except in a strong crosswind.
If you get one done, make sure you can lay the windshield open.
One of the uprights has a pass-through hole inside the welded connection to the tube that goes around the top, so you can snake wires to lights and antennae...Very important!
My plan was to get some Eisenglass for the front and sides. Honestly, I had that with my old bimini top and I always took it down. I like the wind and spray. And when it gets cold, coveralls are cheaper and easier to clean.
|