bearing
I'm thinking you'll need that washer. Did the castle nut tighten up OK without it? (& then you back it off 1/2 turn or so.)
Also like mj said you need to be sure the spindle (round part) is smooth & without grooves on the end closest to the axle or you'll be doing this again pretty soon. Getting a spindle replaced is no big deal, a good welder & a few minutes is all it takes.
Bearings are simple enough, but it's one of those things you want to be very sure to do just right, or you'll be cussing yourself as you sit on the side of the road.
Doug
__________________
Doug
87 Cuddy with a 94 Black Max 200!
& a 1983 Cuddy, looking for power.
|