Macojoe,
Funny thing about the wiring is all the electrical components work. I first just wanted to get all the old wiring harnesses removed from previous electronics that were installed on the boat (I did get any of the old electronics when I purchase the boat). I removed 3 different lines running to the stern for transducers. One had a puck tansducer attached to the inside of the hull.
Whoever did install any components or improvements use marine tinned wire so they had some knowledge of what was correct but took little time to make things organized or neat (unless an owner got into the wiring after a pro did improvements or install).
I can't figure out if the fuse board was factory installed because it was just hanging there under the dash. I couldn't see where they would have mounted or attached it so I mounted it on the roof of the V berth. I guess I will add the wiring for the 192 Garmin that I have from the boat while I'm messing around with the wiring.
Hopefully I will get sometime today to finish the ground wiring to the bus bar.
__________________
Regards Barry
1987 V20 (sold) :(
1996 23' Wellcraft
1991 V20 ;)
|