Quote:
Originally Posted by Skillz
If I am reading this correctly, you can separate the top half of the hull from the bottom half by removing the rubber rail that goes around the outside of the boat and wedging it apart?
I have a '71 V20 that I'd like to do that with. I need to rewire the entire boat and if I can lift up the floor it would make rewiring it a TON easier.
|
Not sure about the liner in a 1971 v20. I think the center consoles had a two piece liner but they all have to be put together at the rub rail. I agree that wiring should be where you can get to it and securely fastened whenever possible. There isn't much wiring to consider on the average 20. Running lights, fuel tank and maybe a livewell pump. Unless you have installed auxillary lights, a windless or something extra all the remaining wires will run thru the rigging tube leading from the console to the stern.