[THEFERMANATOR]

I had a shorter day today as I have to go down tommorrow and get one of the new exhaust pipes expanded so it will fit onto my CORSA muffler. I got MOST all of the wiring in and done today as well as the driveshafts. Since I needed to have the pipe done I decided to take my time and make the wiring as neat as possible. After finishing up the wiring and putting the shafts in I started her up and put it in gear to see if it would go in and it dropped into forward and reverse right away. I also did 3 starts on it with no check engine light so I may be OK in the MIL department. The tachometer works fine since I am driving it off the alternator just like a 6.5 did. I still need to check my speed outputs as I decided to try and use the ECM's and bypas the VSSB(if they don't work I left the wires there so I can hook it back up).

Heres a shot of the engine with the harness's in place(ECM and TCM will be mounted last after everything is together).





Heres the PDC all finished up.


And I spent some time and made an updated insert to go in my PDC for correct fuses and relays.


My toggle switches in and my QUDZILLA guage.


The fuel cooler and you can also see the driveshaft.


And a few underside shots to show how tight the fit is.