A few more pics
So continuing with a few more questions pics:
At the rear drain, the fiberglass is split a bit. I tapped it good and confirmed it's solid, but just wondering if this is typical. I expect this needs some fiberglass (gelcoat?), and will be covered by bottom paint. Pic 1, any concerns here?
Front floor cracks. Pic 2, this is in the lower area as you enter the cuddy. Paint has peeled, and you can see the fiberglass. This area feels a bit soft, and the circular crack outlines the area that's soft. Not sure what's below here, but guessing may need to be cut out and replaced?
A couple more pics of cracks in the floor. These seem to be surface stress cracks and not go through the fiberglass. But open to thoughts. Floor is solid in these areas, confirmed by stepping on and tapping around. Pics 3 and 4
|