Quote:
Originally Posted by JKDOBE07
If i may ask, where did u pick up the through the hull fittings etc??i have to change mine out also, and cant find them and was it a difficult job??thanks
mark
|
http://mareinpartdepot.com
dont worry about the "sale ends today" We established its free shipping whenever you purchase.
changing them was a piece of cake at least on mine....the inside nut came off very easily and a few wacks with a hammer knocked the old ones right out. a little scraping inside the hole to clean it up and a light wet sand on the outside and the new ones were good to go in. The ss ones have two tabs in them that you will need a radiator spud wrench (see picture) so you can stop it from spinning when you tighten the inner nut. they probably have other tools for that but I happen to have one because I have cast iron radiators in my house which I changed the nipples on. you dont need to get them crazy tight anyway i dont think. the sealant is what holds them in place I think
