[THEFERMANATOR]

My question would be is why did it have zero compression? It looks rough, but not bad enough to be zero. I would have expected at least 20 or so from it, zero normally means a hole or MAJOR piston damage. I'm not sure on the EAGLE engines if you can pull a piston out without teardown, but if you could I would start off by pulling just the one piston and looking at the crank journal. The other BIG question is what other damage is there or waiting to happen? Not trying to be the bearer of bad news, just don't want to see you dump a $1K into fixing just one hole and then have it let loose on you on your first trip. At the MINUMUM you need to do a COMPLETE teardown and inspect ALL of your bearings for damage or small chips. I would expect you spend $2500 at a MINUMUM for a teardown and basic rebuild at a dealer on that engine. Most shops down here by me would rather sell you a new one than to build your old one. I know a trusted EVINRUDE dealer down here and won't give an estimate for less than $3500 on ANY V-6 to do a rebuild because you never know what you will run into once your in it.