[bigshrimpin]

Well . . . the shift problem is fixed!! Now onto the the next problem . . . the motor won't go above 2500rpm in gear (with a load). I think it's probably the stator, but I'm no OMC guru. I believe the motor is an 86 or 87 and slow mode didn't happen till 1988/89??? any suggestions. There is decent spark on all 6 clylinders when cranking, and compression is even in all 6. We pulled plug wires on one side and the motor will start . . . and then we did the same on the other side and the motor started, so I don't think it's a power pack. Linkage is advancing through the full range of motion. I'm 100% sure it's electrical, but I'm not sure what else to try beside breaking out a multi-meter and going through each component.