Following everyones advice I was trying to change my gas line to a steel line. The problem I ran into probably has a very simple solution but I just can't find it. The size of the fitting on the Holley carburator is a 1/4" and the one on the pump is 5/16". I got a pice of 1/4 line and a piece of 5/16' line but could not find a reducing fitting to join both of them so for the time being I was forced to join them using a small piece of marine grade fuel rubber line though this I think defeats the purpose of the steel line. I looked for the connection in marine store, auto part store and hardware store. Any ideas.
Here is a small clip where you can see the line with the rubber hose.
http://www.docathome.us/BoatPictures/MVI_1876.AVI
Any ideas?
Thanks